Genuine Milage . . . . . . HONEST

Hi,

You may recall from earlier posts I changed the speedo cable and that didn't fix the problem so a job that has been on the to do list for ages is to replace the speedometer. Found the right model New Old Stock (NOS) on ebay in the states so time to change it out.

Tonight I pulled out the old one and had a play at resetting the odometer readings as I want to keep it consistent.

Old one in very sorry state.

Out and opened up.

Strip the dials.

And back together, lots of pieces, glad I practiced with the old one.

Cheers,

Richard B.

Next . . . . . . New speedo as soon as it arrives and I then have to re-do it again but for real.

Fun in the sand.

Hi All,

Sorry for more non MG stuff but still lots of fun. I have just spent a week in the dunes of Liwa helping Newtrix racing as Chief Mechanic (actually only mechanic) in the 2013 Abu Dhabi desert challenge for 1300 km of desert racing.

The car is a Nissan Patrol with a LS2 V8 corvette engine fitted and it runs in the FIA T1 modified category.

 We had our share of problems, lack of spares limited the amount of repairs that could be done so Ian had the struggle on.

My work base for the week.

Sheared bottom front shock mount.

Burning HT leads at the rate of one a day.

 Rear body mounts to the chassis cracked.

 But it was all worth it in the end.

Completed, everyday with zero penalties and finished 16th overall and 2nd placed GCC entry which was an amazing result.

Cheers,
Richard B.

Next . . . . . I have just ordered a new speedo from the states so I will be cutting my hands to ribbons under the dashboard.

Nuts and Bolts

Hi All,

One of the jobs that has been due for a long time is sorting out all my nuts and bolts. I have had a plastic sorting boxes for years but they have always laid on a shelf and not been as organised as I wanted. So a few sheets of plywood and a but of time with table saw and a router and sorted !.

So what is in them all.

Top shelf is for small assortment boxes :-

-          Circlips, Split pins, Rivet Nuts, ‘O’Rings, clevis pins, roll pins and springs.

Then in the boxes on the regular shelves one for each :-

-          Small screws and self tapping screws.

-          Large screws and raw plugs

-          Metric nuts and bolts M10 and bigger

-          Metric nuts and bolts M8 and smaller

-          Washers.

-          Imperial nuts and bolts.

-          Electrical bits, fuses, relays and heat shrink.

-          Electrical crimp terminals.

-          Hose clamps and air fittings.

-          Abrasive paper (in A4 folder).

-          Pop rivets and staples.

-          Plastic body clips.

-          Batteries.

These are the parts boxes I use. They are a bit flimsy but gluing in the orange removable dividers solved that problem.

The shelves are just screwed and glued into dado grooves I routed into the sides.

Castors to keep it mobile to take to the track.

An a lock, not that I don;t trust you but ......

Cheers,
Richard B.

Next . . . . . . . Not sure.